Application Perf Mgmt (BAC / BSM) Practitioners Forum
Showing results for 
Search instead for 
Do you mean 

BSM9: Patches for Distributed Environment question

Valued Contributor

BSM9: Patches for Distributed Environment question

If I have a Distributed Environment with two DPS and 2 GWs, do I need to isntall the BSM9 patches (9.13) on these ?

 

The are not full BSM 9 isntalaltions, only DPS adn GW installs only.

 

I have foudn that isntalling these patches with services down on the DPS and GWs that when bringing back up it fials and also Configuration Wizard fails.

 

Any ideas on this?

 

Thanks.

Tex2020
3 REPLIES
HPE Expert

Re: BSM9: Patches for Distributed Environment question

If patch installation instructions say to install the patch on both GW and DPS, that means the patch MUST be installed on ALL GW and DPS servers you have in your BSM deployment regardless of how many GW/DPS servers you have.

Highlighted
Trusted Contributor

Re: BSM9: Patches for Distributed Environment question

Hi TEX,

 

Yes, you should intall this patch(9.13) on all the servers(DPs & GWs).

 

I too have distributed Environment, with 2 GWs & 1 DPS. I had BSM 9.12 earlier and now installed 9.13 patch on this.

 

I didn't face any failures while bringing them back.

 

Regards,

Ashok 

Trusted Contributor

Re: BSM9: Patches for Distributed Environment question

Dear Ashok,

 

You need to install service pack 9.13 on all the servers in your enviornment. There perform connect to DB from each server and then start the services starting from Primary DPS followed by gateway servers,

 

Thanks !

Regards,

Abhijeet