Ether-Channel between HP2848 Switches using Wireless Ethernet Bridges

[Tekkie123]

Hi,We have two branch offices connected through Wireless Ethernet Bridges(20Mb/s & 10 Mb/s), with HP2848 on each branch.Currently only one of the links is operational. I want to utilize both radios so that their bandwidth could be bundled together.
I have tried using ethernetchannel configuration (using LACP)but it's not working, as in this case one of the ports go down.
Kindly someone suggest in this regard.

Thx
Tekkie!!

[Shadow13 · Accepted solution]

to use LACP the links must be the same speed and duplex, in your case you can use TRUNK and it should work with no issues

#trunk trunk

[Tekkie123]

Dear Friend!!
Basic problem is solved thx to your advise:)
I just configured all switch ports attached to both Wireless Ethernet Bridges at each branch to:
"speed-duplex 100-half
no lacp
trunk 43-44 Trk20 Trunk"
Now the ether-channel is working & I can see traffic passing from both bridges.Athough im not sure whether the traffic is being distriuted equally.

There is one problem,,redundancy is not working. When I disconnect one Bridge, the link to the branch goes down, & it does not come back up until I connect it back.
I hope its a small problem now that the main problem of cascading both links is done.
Really appreciate ur help!!

Thx
Tekkie123