HPE Community
Comware Based
1751781 Members
4405 Online
108781 Solutions
New Discussion

HP E5500G Switch Series

 
RedBarchetta
Occasional Collector

‎01-02-2014 08:24 AM - last edited on ‎01-02-2014 07:32 PM by

‎01-02-2014 08:24 AM - last edited on ‎01-02-2014 07:32 PM by

HP E5500G Switch Series

Hi,

Apologies if this has already been discussed. I am not familar much with the 3COM/HP suite of switches and have a new requirement and hence the post....

 

The site in question has a mixture of 3COM and Cisco switches and all devices are configured in the same VLAN - not a good design practice I know, but the site as grown with little considersation.

 

I have a requirement to be able to collect data which is seen across all ports of the 3COM which is then uplinked to a Cisco switch via the fibre connection to where the collector resides. Had all the switches been Cisco, I would have implemented RSPAN but on the 3COM the setting is PORT MIRRORING.

 

Would someone be able to provide how I would go about setting the 3COM to send such traffic via the uplink port (Gi1/0/52)?

 

If a sechmatic helps please let know and I will knock one up.

Thanks,

Red.

 

 

P.S. This thread has been moved from ProCurve / ProVision-Based to Comware-Based. -HP Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.