- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: Reset HP A5120 24E1 switch
Comware Based
1752679
Members
5759
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-06-2012 02:03 AM
12-06-2012 02:03 AM
Reset HP A5120 24E1 switch
Hello,
I have this switch which is faling to boot properly. The first error I observed was:
Loading error in CRC checksum
No correct file to boot
When I tried to reset switch it failed. Now I am thinking of formatting switch then downlaoding the OS from a fucntioning switch and upload it to this one. Anyone with the steps to do this?
It will be highly appreciated
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-08-2012 03:00 AM
12-08-2012 03:00 AM
Re: Reset HP A5120 24E1 switch
If you interrupt the boot process with a serial console cable connected, you can upload a new OS image via xmodem. I use a Linux system with minicom for this, but Windows Hyperterminal should work as well.
Don't be surprised if you upload a new image and the same problem persists. Images are checked when they are loaded and a corrupt image should be rejected before it is loaded into flash memory; therefore you probably have faulty flash memory and will end up needing to replace the switch.
Don't be surprised if you upload a new image and the same problem persists. Images are checked when they are loaded and a corrupt image should be rejected before it is loaded into flash memory; therefore you probably have faulty flash memory and will end up needing to replace the switch.
Regards,
Paul
Paul
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP