HP 830 only switch engine accessible via CLI

[MarcisB]

Hello

I have new HP 830 on my hands which only allows me to access it's switch engine from CLI.

I can access both wireless and switch part from web.

Please correct if i am wrong but from CLI as well - wiress part comes first and then you can go to switch engine via "oap connect slot 0" command.

How can i access wireless controller part from CLI?

Any ideas?

Because i could not find any troubleshooting guide about this.

[Georgeisaac]

Hi,

Switch side to controller - Ctrl+K

Controller side to switch side - oap connect slot 0

George Isaac

For more info :  www.newdaywireless.wordpress.com

[MarcisB]

Thanks. I am aware of that.

But that was not the issue.

Most likely that was a remants of some unsuccessful upgrade which was not completed fully.

I deleted all firmware files from device and upgraded it once more from Bootware.

Now it boots properly.