Comware Wireless / Unified Series
1748053 Members
4721 Online
108758 Solutions
New Discussion

Re: How to access the HP 525 802.11ac

 
Saracen1
Occasional Contributor

How to access the HP 525 802.11ac

Hi,

 

The IP address is awarded for the AP via DHCP. Tried to access the device with http, and could not connect. I can connect via telnet but asks for a password. What is the default password for the AP?

 

Thanks for any help.

5 REPLIES 5
johnk3r
Respected Contributor

Re: How to access the HP 525 802.11ac

Default password is: admin


You can connect the console port? This AP is being managed by a Controller?

**************************************
ATP FLEXNETWORK V3 | ACSA
RamKrish
Valued Contributor

Re: How to access the HP 525 802.11ac

HP525 AP is controlled mode only AP and cannot manage the AP seperately.

 

Telnet would require support privilege which only avialble for TAC support.

 

Console is basically not useful once AP has joined the controller successfully.  So manage the AP only from controller.

 

If you HP525 is not yet connected to any Unified controller and trying to troubleshoot, then console should help you.

Regards
Ram
Xirixiz
Visitor

Re: How to access the HP 525 802.11ac

Hi,

I recently bought this device as well. Unfortunately I assumed it would be posible to configure the device without a unified controller. The device hasn't been used yet and it's meant to use at home. Is it possible to login and/or configure the device somehow?

Regards,
Bram van Dartel

 

NBRYAN
Occasional Visitor

Re: How to access the HP 525 802.11ac

What are the console settings for the 525?

 

Thanks,

Neil

Transport
Advisor

Re: How to access the HP 525 802.11ac

Telnet access to a controlled AP is still usefull for troubleshooting a single AP.

If you are in this situation, I recommend this procedure:

http://abouthpnetworking.com/2014/10/09/unified-wireless-ap-consoletelnet-access/