Data Protector Practitioners Forum
Showing results for 
Search instead for 
Do you mean 

TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

Occasional Contributor

TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

Hi All,

 

I am using HPDP V 6.1.

 

Recently i run a command i.e. omnimm -reset_poor_medium MediumID for making the poor tape with green status.

 

soon after that command my tape status become green however, Tape status got blank, i am not able to restore data from that tape now. I already scan that tape too. But getting blank status

 

Regards,

Rav

 

 

5 REPLIES
Honored Contributor

Re: TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

Hello

 

What was the tape status before goes to poor state? Why the tape has been marked as poor?

 

To use this command is not the solution just a workaround you must analyze why tapes are being marked as poor.

 

I guess that tape header is corrupted and for this reason is marked as unknown, you can check it with tapeanalyzer tool.

 

              %DATAPROTECTOR%\bin\utilns\TapeAnalyser -device <logical device> -summary
                Where <logical device> is the name of the logical device as declared in Dataprotector
                exemple: scsi0:1:0:1C
                You have to load the tape in the device before lauching the operation.

Occasional Contributor

Re: TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

It was working fine with green status before became poor (red)

 

That tape automatically got poor...

 

it was using since long time for the incremental backups on daily basis.

 

 

Is there any impact on the tape drives,others tapes if i run that Tape Analyser tool?

 

Do i need to free both the drives before execute Tape Analyser?

 

Also do i need to stop/start the omnimm?

 

 

 

 

 

 

 

 

Honored Contributor

Re: TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

Hello

 

Please check last session that wrote in this tape you must see any error message, this is the issue that you must pursuit.

 

Is there any impact on the tape drives,others tapes if i run that Tape Analyser tool?

 

NO impact in the rest of tapes

 

Do i need to free both the drives before execute Tape Analyser? Just the drive where tape will be loaded

 

Also do i need to stop/start the omnimm? Not

 

best regards

 

Occasional Contributor

Re: TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

Executed Tape Analyser however, got and error message , (see attachment)

Also could you please exactly tell from where i take value of <logical device>

 

I had given as per your example (i.e. exemple: scsi0:1:0:1C).. so I took it from devices>MSL>Drives>drive0>drive>select SCSI address.

Highlighted
Occasional Contributor

Re: TAPE GOT BLANK AFTER omnimm -reset_poor_medium MediumID command

SCSI value taken from location 

 

see attachment