Data Protector Support and News Forum
Showing results for 
Search instead for 
Do you mean 

How to address huge number of filenames

Occasional Advisor

How to address huge number of filenames

Hi all,


I have an issue where I am running very close to the red zone of huge number of filenames in Internal Database > Usage > Catalog Database ( screenshot attached )


How do I address this?

What is the best method to allocate the filenames; purge or any other effective method?


Looking for best practice, as I expect there will be a warning or a possible issue soon.







HPE Expert

Re: How to address huge number of filenames

You didn't mention what version of Data Protector you are runnng, so I am going to assume it si 7.x or below


The screenshot you sent has one shortcoming... it does not show what is the type of UNIT (individual records? kb of Records?) so, taking it as individual records, you have about 44M filenames stored


Looking at the Limitations section of the Product announcements guide for filenames:


48 GB or approximately 1050 million (UNIX systems) or 675 million (Windows systems)


I think what would have been more useful here is to get output from


    omnidbutil -info

    omnidbutil -extendinfo


so that the degree of IDB fragmentation could be observed as well as seeing if new Tablespaces need to be created


However, to answer your question directly, you should periodically run a purge of filenames:


    omnidbutil -purge -filenames -force


maybe once every couple of months.  If you have not deone this recently, or evr, it may take quite some time.  You can get a VERY rough estimate by running


    omnirpt -report db_purge_preview


You can also use this to time your purging by only purging fienames of cetain systems


    omnidbutil -purge -filenames host_A host_B host_C -force


You can stop a purge at any time by running


    omnidbutil -purge_stop


A checkpoint will be written to the IDB, and when you start the purge again, it will be picked up from this point


There is nothing that will indicate the progress of this command except returning to the command prompt


About once every 6 months, I recommend that you write out teh IDB, and read it back in todo a thorough purge of everything, not just the filenames.  I have attached procedures for UNIX and Windows


When doing any of these operations to the IDB, you should not have anything (Backups, REstores, Copies, Media) running.  At the command prompt on the cell maanger, you can run


    omnitrig -stop



Occasional Advisor

Re: How to address huge number of filenames

Hi Bob,


Thanks for taking the time to write a detailed reply.


I am using DP 6.20 on a Windows 2003 server.


Attached is a screenshot of both omnidbutil and omnirpt_preview commands.





Honored Contributor Honored Contributor

Re: How to address huge number of filenames



You don't actually have a lot of file names ;)


Don't pay attention to the "red zone" visualization or the 99% usage the DP GUI displays, as these just show the relation of currently allocated records to the total size of the so-far allocated table space. This is almost always 99% full, as the table space is only allocated more disk blocks when actually needed. You so far have no CDB extensions except for a single one to fnames.dat, and that one is only 50% filled so far. Compared to other IDBs I've seen that's tiny. For the time being, you can comfortably grow your CDB by adding extents. I typically extend a table space of the CDB when the previous one exceeds 50% fill, so in your case, it is the right time now to add another extent to fnames.dat as well as to fn1.ext. Apart from that, you are living well in the specs. BTW, since this is 6.20 on W2k3, I assume it's not just running since yesterday, so the dynamics are actually quite relaxed. Or did this start to grow significantly just shortly?