Need help setting up an A3312A Jamacia enclosure

[Bit_Freek]

Salutations,

This is my first post on this forum so if this thread is in the wrong section please inform me. Here is the scenario currently I am attempting to set up the A3312A enclosure. I need a little help troubleshooting though, so I begain by setting the bus's for each drive bay i numbered them 0-8 (skipped 7) then I put 4 A3714AM 18.2 gb se hard drives in the unit. I also put a scsi cord from bay a to bay b to bridge the bus's and installed a terminator on the last open slot. I am using a scsi vhdci to lvd cord to connect the array to a proliant dl380 g4. I cannot get the drives to show up. I have tried using multiple cards including a HVD card but cannot get the drives to show up in the bios. Any help would be greatly apprecated. I have a full warehouse of parts at my disposal so if it is beyond configuration and hardware related suggested replacement part numbers would be a great help. 

Thank you, 

B

[Bit_Freek]

Problem resolved, I was using the wrong type of terminator. Please close or remove this thread.