HPE Community
Disk
1752586 Members
3729 Online
108788 Solutions
New Discussion

2800 with firmware 2.6.0c and forgotten password

 
Roger Larsen
New Member

‎04-02-2004 12:42 AM

‎04-02-2004 12:42 AM

2800 with firmware 2.6.0c and forgotten password

I need to downgrade with a password reset firmware trough the internal serial interface and tftp.. any idea where to get the password reset firmare for 2.6.0c ( think it is 2.0.0. something ??
0 Kudos
1 REPLY 1
Mike Naime
Honored Contributor

‎04-02-2004 11:41 AM

‎04-02-2004 11:41 AM

Re: 2800 with firmware 2.6.0c and forgotten password

I don't know if they disabled this or not...

Have you tried the RESET TO FACTORY DEFAULTS at the front panel display? This would change all of the passwords and other settings back to factory defaults.

You would then need to re-configure the switch back to what you had.

I did this about 2 years ago on a switch that a newbie fat-fingered the new password setting. So I'm not sure if the 2.6.0C will still allow you to do this.

Mike Naime
VMS SAN mechanic
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.