HPE Community
Servers - General
1752451 Members
6285 Online
108788 Solutions
New Discussion

HP Power Protector 1.02.28 and connection loss

 
Lurchi123456789
New Member

‎12-06-2013 03:24 AM

‎12-06-2013 03:24 AM

HP Power Protector 1.02.28 and connection loss

Hello,

 

in HPPP I configured a power source with two R5000 UPS over network interface lwith latest Firmware) . Everything is fine for 2 minutes, but then HPPP looses the connection to the two UPS. And there is no way to connect them again. Only possibility is to delete the power configuration an d configure it again. But after 2 minutes the same problem.

 

Does someone know the problem?

 

Thanks!

1 person had this problem.
0 Kudos
Reply
1 REPLY 1
PatrickGoes
New Member

‎01-30-2017 10:57 PM

‎01-30-2017 10:57 PM

Re: HP Power Protector 1.02.28 and connection loss

Same problem here. HP-HPPP 1.04 build 046 on the client. "communication loss" after a few minutes. Any soiution yet?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.