- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Hyper-V USB on DL380p Gen8 with P420i Controler.
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-11-2015 03:59 PM
11-11-2015 03:59 PM
Hyper-V USB on DL380p Gen8 with P420i Controler.
Hey Everyone,
So I am wondering if anyone has run into the same issue that I am having... also if they have found a fix? I have a HP DL380p Gen 8 Server, With P420i Raid Controller with 25 disks.
I am trying to setup and configure a Hyper-V USB Stick with HyperV Server 2016 core. I am looking to use to use storage spaces so I have set the 420i to hbamode so the OS can see the disks. ( Raid 0 and pass through do not work with out doing this it seems for this controller) However when I do this and boot the USB copy of HyperV I get the Inaccessible_boot_Device error on boot. Now I have added the Drivers for the P420i but this has also made no difference.
On a side note I also tried doing a direct install to a Hard disk and although the windows installer could see all the drives it would not install.. This is because the installer states none of the drives where bootable... So I am wondering if this is related to the above issue.
Now leaving the fact that I am playing with 2016 to the side for the moment and also keep in mind that I have of course had a poke about in the bios in relation to the above boot issue ( Fyi, Not really anything was found there to asssit )
Any one have any ideas ?
Cheers!