- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- 6125 blade switches and console
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-01-2014 04:16 AM
04-01-2014 04:16 AM
Hi!
Currently on the back of the C7000 I have two 6125 blade switches in the enclosure (attach OA scr.jpg).
When you try to connect to one of them in the console, I see the characters (attach Scr console.jpg).
To connect using cabel RJ45-DB9 and programm PuTTY (attach Scr conf Putty.jpg).
I tried to change the "Remot character set" in PuTTY, but to no avail.
Need some help.
P.S.: Sorry for my English skills. I used an online translator (
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-01-2014 04:19 AM
04-01-2014 04:19 AM
Solutionssh to the OA, then "connect inerconnect ..." to the switch.
Better results?
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-01-2014 10:42 PM - edited 04-02-2014 12:44 AM
04-01-2014 10:42 PM - edited 04-02-2014 12:44 AM
Re: 6125 blade switches and console
Torsten thanks, it works!
I asked ip adress for both switches. But they unknown by the console (attach Scr1.jpg).
Directly on the Web interface are available.
How to manually specify "Managment IP address" and Managment URL ?