Brocade_switch_reset_to_default

[chuckk281]

Yoji needed to get back to a basic setting on a Brocade SAN switch:

*****************************************************************************************************************

> Hi experts,

>

> Could you tell me how to reset a Brocade 8Gb SAN switch for c-Class to

> factory default configuration ?

>

> As I see the following manual page 88, configDefault command resets

> non-persistent configuration data to factory defaults.

>

> http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c01711371/c01711371.pdf

> "Brocade Fabric OS Command Reference Manual v6.2.0"

>

> But several parameters on page 88 (IP address etc.) cannot be reset by

> configDefault command.

>

> How can I reset these parameters ?

> I have to reset (or delete?) them individually ?

***************************************************************************************************************

Marcus responded:

*************************************************************************************************************

Does 'configdefault' take you anywhere as it would on the regular FabricOS?

Then you should be able to run the initial config dialog.

***********************************************************************************************************

Any comments? Other suggestions? Brocade experts?