BladeSystem - General
1745826 Members
3961 Online
108722 Solutions
New Discussion

Re: Emulex 10GB Flex Fabric Fails AFter Firmware Update

 
Elorion
New Member

Emulex 10GB Flex Fabric Fails AFter Firmware Update

I recently upgraded the firmware of the Emulex 10GB NC553i FlexFabric controllers in my BL620c G7 blade from a firmware revision of ~ 4.5.X to the latest of 10.5.X and now it just loops on initializing the controller ultimately failing. It just shows Xs during the boot cycle. It was working fine prior to the update and now...nothing. Can anyone advise how to recover from this? Downgrade etc? Please help!

 

Elo

 

 

2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: Emulex 10GB Flex Fabric Fails AFter Firmware Update

Try to boot one of these:

 

http://h20564.www2.hpe.com/hpsc/swd/public/detail?sp4ts.oid=4194639&swItemId=co_137306_2&swEnvOid=54

http://h20564.www2.hpe.com/hpsc/swd/public/readIndex?sp4ts.oid=4324631&swLangOid=8&swEnvOid=54

http://www.emulex.com/downloads/emulex/firmware-and-boot-code/oce11100-series/firmware-and-boot-code/


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
gavrilenkov
Advisor

Re: Emulex 10GB Flex Fabric Fails AFter Firmware Update

I got on the same rake hit. Solution - Download the ISO image of firmware from EMULEX? Boot from this image, adapters and sew it back into place. After that you can flash, but I did not sew the latest SPP HP_Service_Pack_for_ProLiant_2015_10