- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- NC553i CNA iSCSI timeout settings
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-24-2013 02:21 PM
06-24-2013 02:21 PM
NC553i CNA iSCSI timeout settings
We have a few BL460c G7s which are using a couple of NC553i “functions” as iSCSI HBAs. I need to configure the “NodeTimeOut” and/or the “LinkTimeOut” to 60 seconds, to survive long controller failovers on our SAN. From everything I’ve read, the defaults for these are 30 seconds.
It sounds like such a simple thing, but for the life of me, I can’t figure out how/where to change these settings. I’ve looked everywhere in the OCManager GUI, and also the “hbacmd.exe” options, but am finding nothing on either setting. When researching this online, I see many screenshots for the settings, but the GUIs are different from ours.
I've just gone through the Emulex OneCommand Manager user manual, and it talks about the ability to change host driver parameters. However, there is a note that reads "If there are no discovered FC or FCoE adapters, the entire Host Driver Parameters tab is grayed-out. This occurs because there are no adapters to which the host driver parameters apply." Indeed, we are not using FC or FCoE personalities - only 10Gb Ethernet and iSCSI.
Does this mean iSCSI timeout settings cannot be changed? Surely not, but I'm finding no answers :|
- Tags:
- iSCSI