HP 4gb Fibre Channel Pass Thru Module

[spekyteky]

Hi there,

Looking for some information on the HP 4gb Fibre Channel Pass Thru Modules, I have a few of these that as i was hoping to use in a HP Bladesystem C7000 enclosure but i think a couple maybe faulty but not really sure..........when i install a couple of them the LED's are not illuminating and a couple show the internal health LED flashing very quickly....do they hold or can they hold a former configuration if used in another system in the past? Can they be factory reset? I do not have them connected to anything as of yet.....i have managed to update the firmware  with no issues and when i view them in OA Web Page they seem fine no faults reported...........I am quite new to this so any help would be appreciated 

Cheers.................

[Torsten.]

This is all you can find about:

http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=2510341&docId=emr_na-c00700737&docLocale=en_US

[spekyteky]

Thanks Torsten,

I had seen that already but there isnt much information in it to go on......thanks anyways.