- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: DirectAttach Fibre Channel with 3PAR not worki...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-28-2014 04:30 AM
03-28-2014 04:30 AM
hello everyone,
With our new enclosure, we are encountering issues when implementing Direct-Attach with our 3PAR StoreServ. We connected 2 ports from VC1 and 2ports from VC2 to the 3PAR controllers.
We defined 4 san fabrics as you can see in the screenshots attached. First, we've noticed that there was no WWN defined in the "Connected To" column: It shows "
But still we created a server profile for a blade we used for test. And as we could expect, in the HP 3PAR Console Management, we can't see the WWN shown in the test server profile.
We can't see where the problem could come from as there is no alerts raised by the enclose, no errors in the logs and the status is even green when displaying the san fabric properties.
Any idea?
Thanks a lot,
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-03-2014 04:02 AM
04-03-2014 04:02 AM
Solutionhello everyone,
We figured out how to make it work. It was so simple! We fixed it by rebooting both of the virtual connect.
Then, we could see the WWN when showing the SAN Fabrics definition: "Conneted To:" column.
Hope it would be helpfull to someone else,
thanks,