HPE Community
BladeSystem - General
1753325 Members
4874 Online
108792 Solutions
New Discussion

Firmware Update for Virtual Connect Modules

 
grinningdevil
Frequent Advisor

‎07-11-2016 08:11 PM

‎07-11-2016 08:11 PM

Firmware Update for Virtual Connect Modules

Hello !

Need help in upgrading firmware on my Virtual Connect Modules. 

Infra : In the VCSU healthcheck results, we get one “primary”, one “backup”, and 2 “subordinate” modules.  

Question: 

To update firmware, which one should we upgrade first ? Any of the subordinates ? or Backup ? 

I'll be either using HP SUM from Windows Machine, or will use VCSU utility for upgrading the firmware.  

Attaching the screenshot of VC Modules. 

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎07-12-2016 04:50 AM

‎07-12-2016 04:50 AM

Re: Firmware Update for Virtual Connect Modules

You will update all in a single session, but you can control the activation (reboot) order.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.