- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: Virtual Connect VMware vDS LLDP
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2016 06:30 AM
02-17-2016 06:30 AM
Virtual Connect VMware vDS LLDP
Hello,
i have a BL465c G/ Blades with a Virtual Connect Profile (HP VC Flex-10 Enet Module, Firmware 4,41) assigned to it.
In vSphere vCenter i have configured a vDistributed Virtual Switch with LLDP, but i cannot see any LLDP Information (Link Layer Discovery Protocol is not available on the physical adapter)
There should be LLDP Information from the VC Module.
Peter
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-18-2016 04:24 AM
04-18-2016 04:24 AM
Re: Virtual Connect VMware vDS LLDP
ssh to the VCManager, use the following commands:
show lldp <PortID>
Xn for Uplink or dn for downlink, e.x. X2 or d16
To enable network loop protection, use the set loop-protect command:
>set loop-protect Enabled=true
To reset network loop protection, use the reset loop-protect command:
>reset loop-protect
Regards