Factory HBA

[BobsYourUncle]

Is there a way to obtain the Factory WWNs of blades that have been assigned by VC.

We are moving these blades to a Non VirtualConnect chassis and want to pre-stage zoning for that host.

[Robert_Jewell]

I dont beleive so.  It would seem that unless you remove the FC ports from the VC domain, the firmware on the blades will display the VC given WWNs.

-Bob

[Jimmy Vance]

I don't recall if the WWN is on sticker attached to the Mezz card itself. During POST you can access the settings of the HBA and see the WWN ID