- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Monitoring of C7000 G3
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 04:31 AM
02-08-2016 04:31 AM
Monitoring of C7000 G3
Hello all,
Recently we acquired the latest C7000 G3 Blade Enclosure with OA firmware 4.45. We also installed the latest HP Device Management Service (1.2.3) to get the monitoring flowing in our SCOM enviroment. However, with all our older blades (with older firmwares) the monitoring works fine, but for the new one the Device Bays and Interconnect Bays aren't monitored. Also see the attached screenshot:
Everything appears to work fine, also Thermal and Power monitoring, just not the Bays. We've inserted two servers which I installed and they, of course, work fine. The Virtual Connect in Bay 01 and 02 als work like they should. The VC does get monitored however, but this is probably due to the fact that it's a different SCOM management pack.
Any suggestions would be highly appreciated! We suspect it's a firmware issue, but are not too sure. Thanks!