HPE Community
BladeSystem - General
1752794 Members
6696 Online
108789 Solutions
New Discussion

Need to know how to change the output of the Hpsreport utility.

 
acorra
Occasional Contributor

‎01-02-2012 08:28 AM

‎01-02-2012 08:28 AM

Need to know how to change the output of the Hpsreport utility.

Hello,

 

   I´ll appreciate if you can tell me how I can change the output of the rpsreport utility.   Currently my C driver (Windows/System...) is almost 100%, therefore i need to send the output to D or F driver.

 

Regards

Alberto

0 Kudos
Reply
1 REPLY 1
Murali_V
HPE Pro

‎01-02-2012 08:25 PM - edited ‎01-02-2012 08:26 PM

‎01-02-2012 08:25 PM - edited ‎01-02-2012 08:26 PM

Re: Need to know how to change the output of the Hpsreport utility.

Hi,

 

You can use the Optional command line switches - /report <dir>  - To redirect the location of the reports and CAB files generated.

 

Refer Readme.TXT for more informaion.

 

Regards,

Murali Mohan

Was this post useful?

Accept or Kudo

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.