HPE Community
BladeSystem - General
1753776 Members
7025 Online
108799 Solutions
New Discussion

W2K8 Server - HP BL25p

 
Bruce Kenworthy
New Member

‎11-12-2009 12:16 PM

‎11-12-2009 12:16 PM

W2K8 Server - HP BL25p

I am installing Windows 2008 server on an HP Blade- BL25p and cannot get the nic going. I have found that I see a media not connected error when I check the nic through ipconfig /all. I had installed the server through iLo with no problems -just cannot figure out what I am missing to get connected through the nics on the Windows 2008 installation.
0 Kudos
Reply
1 REPLY 1
Magnus von Rosen
Frequent Advisor

‎11-12-2009 11:20 PM

‎11-12-2009 11:20 PM

Re: W2K8 Server - HP BL25p

Hi!
32 or 64 bit windows? 2008 R2 or the one without "R2"?
Did you install using smarterstats och did you install the Support pack after installation?
Which kind of Switch is in you enclosure?

No unknown hardware in device manager?

Cheers!

/Magnus
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.