- Community Home
- >
- Servers and Operating Systems
- >
- Server Clustering
- >
- Re: Small Monitoring Daemon (SMD) does not start o...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-28-2014 06:18 AM
04-28-2014 06:18 AM
Small Monitoring Daemon (SMD) does not start on some nodes CMU 7.1
I'm doing some fancy cloning,
we have several clusters, same HW, so I want to reuse the image
from one node to another cluster, same disklayout etc.
I do a dummy install with the right disk partitioning.
Then I replace the image files partachi-sda*.tar.bz2
Deploy image ok, and runs as expected, so far so good, this works fine on a OS level.
But CMU does not like this, the SMD does not start on the nodes.
I can get it to start if I do (in the CMU GUI) Monitoring -> stop then start Monitoring Engine.
But when I reboot a node SMD doesn't start on that node.
Any advice ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2014 06:46 AM
04-29-2014 06:46 AM
Re: Small Monitoring Daemon (SMD) does not start on some nodes CMU 7.1
How many nodes do you have in your cluster?
Are all nodes part of network entity ?
Do you mean that every time when you reboot a compute node, you need to restart monitoring to get SMD running on compute node?
did you wait for few minutes after node boots successfully?
Please Increase monitoring debug level CMU_SEC_MONITORING_DEBUG_LEVEL and CMU_SMD_MONITORING_DEBUG_LEVEL to 9 in cmuserver.conf
Restart monitoring daemon, wait for few minutes. Then reboot one compute node, wait for few minutes and check if monitoring starts.
Please check these logs for errors:
On compute where secondary monitoring daemon is running:
/opt/cmu/log/SecondaryServerMonitoring_<hostname>.log
On problematic node:
/opt/cmu/log/SmallMonitoringDaemon_<hostname>.log
/opt/cmu/log/smd_start_<hostname>.log