HPE OneView
1748051 Members
5103 Online
108758 Solutions
New Discussion

Re: Clearing locked alert status

 
ChrisLynch
HPE Pro

Re: Clearing locked alert status

Can you tell me what iLO firmware version you are using?


I am an HPE employee

Accept or Kudo

JSmid
Advisor

Re: Clearing locked alert status

version 2.03

MeFromil
Frequent Advisor

Re: Clearing locked alert status

Hi 

i have the same problem And fix it by next step 

1. Update Server Firmware

open Putty to Onboard admin

try to reset the Bay ILO by typing :

connect BAY X

reset /MAP1

JSmid
Advisor

Re: Clearing locked alert status

Yes! this has solved the issue. Thank you!

Afridi43
New Member

Re: Clearing locked alert status

Kindly perform a clear NVram on the server with the profile locked.

 1-     Power off the server and locate the system maintenance switch  ( check the mapping on server’s access panel)

2-     Move switch S6 from default 'Off' position to 'On'

3-     When a message indicates that a maintenance switch has been turned on and the unit has been reset, power it off

4-     Reverse switch S6 and reboot again

 

Tapper3
New Member

Re: Clearing locked alert status

I tried all of the suggestions above and none worked.  Finally I just removed the enclosure from HP Oneview and then readded it.  This worked!!  All of the logs are still there, but the Locked staus has now been cleared.  I am using HP Oneview only for monitoring so it was easy to remove the enclosure.  This really would not work for prople who use HP Oneview to manage their enclosures.

Juliano_Flores
Occasional Advisor

Re: Clearing locked alert status

Hello MeFromil,

This solution really works: after 15 HP OneView alerts, all was solved with this tip.

Thanks a lot!