- Community Home
- >
- Software
- >
- HPE OneView
- >
- OneView 1.1, VC Flex10D & VC FC (8gb 20port) Stuck...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-17-2014 02:14 PM
07-17-2014 02:14 PM
OneView 1.1, VC Flex10D & VC FC (8gb 20port) Stuck Adding VC FC Modules
Greetings--
Have downloaded the long-awaited 1.1 appliance for the VC FC Module support and am attempting to import a new/clean enclosure that contains 2 x VC Flex10-10D Modules and 2 x VC FC 8GB 20Port Modules.
Enclosure and Flex10Ds import fine; however, after about 3 minutes the VC FC Module imports fail, saying interconnect response time-out. Interconnect could not be brought under management.
Now the modules are stuck in a state of Adding.
Have tried powering off all the modules, clearing VC from the OAs, verifying I can ping the VC FC module IPs, removing & readding the enclosure, and manually verifying firmware is updated everywhere.
Anyone have any thoughts before I go and open a support case with HP?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-18-2014 12:33 PM
07-18-2014 12:33 PM
Re: OneView 1.1, VC Flex10D & VC FC (8gb 20port) Stuck Adding VC FC Modules
Followup for anyone else...
We opened a case and after getting escelated, we got the problem resolved. The solution, as with everything (and of course it was so obvious we didn't try it)... was to simply reboot the OneView appliance.