HPE Service Manager / Service Center Support and News Forum
Showing results for 
Search instead for 
Do you mean 

How to map the Connect -i IT table fields at one stretch or automatically.

Highlighted
Occasional Advisor

How to map the Connect -i IT table fields at one stretch or automatically.

Dear All,

 

I'm very curious to know if in case  there are any methods to map the connect it feilds at one stretch.

Sometimed It is quite obvious that , the source and the detination tables might have more than 100 fields to map, mapping each one of them manually is going to consume more time.

 

So kindly suggest me some methods to map all the fields at one go, should be like select all and mapp all at one go.

 

Thank you in advance

 

Yogesh

 

 

 

1 REPLIES
HPE Expert

Re: How to map the Connect -i IT table fields at one stretch or automatically.

Hi Yogesh,

 

As far as I am aware there is no way to map multiple fields at the same time.

 

However, it is possible to map whole tables by dragging and dropping the table name of the source table to the table name of the destination table. Not sure how useful this will be as source and destination tables could have quite different fields, but you can give it a try and see if it will meet your needs.

 

I am attaching here a small screenshot from a mapping where I mapped two identical tables using this approach. I hope this will help.

 

Best regards,

Elisaveta