- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- Microsoft System Center Integration
- >
- HP SCOM Agentless Server state not resetting.
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2014 03:14 AM
12-05-2014 03:14 AM
HP SCOM Agentless Server state not resetting.
I've set up the HP ProLiant Agentless Management Pack (v 3.2) for Microsoft System Center in an instance of SCOM 2012. I've added a couple of HP DL320e servers as agentless servers with the HP ProLiant Agentless Management Service. I successfully get alerts through to SCOM via iLO and the Device Monitoring Service e.g. for a NIC failure and the health monitor in SCOM for the agentless device goes red.
The problem I have is that the health monitor in SCOM does not return to green after the NIC connection is restored. Looking at the definition, the monitor should run every 15 minutes. I've tried leaving it overnight and it still doesn't go green. This is the case whether or not I close the alert.
Is it supposed to reset by itself. If it is, any idea why not?
Also, the alerts only appear in the top level "Active Alerts" folder, not within the Active Alerts folders within the management packs. Is this to be expected?