- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- HP SIM and ESXi
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-03-2015 01:41 PM
08-03-2015 01:41 PM
HP SIM and ESXi
Hi,
I installed HP SIM couple of week ago with the idea of having a patch solution for our ESXi environment (install software & firmware but i cant get it to do what i need.
The installation should be fine as i used the guided wizard (not the custom one).. then I downloaded the SPP and uploaded into VCRM and after that I attached the baseline to couple of HP 585DL ESXi (5.5 version) servers we have in our lab.
In HP-SIM I can see the HP installed software they have and also it compares against the baseline (its currently telling me that they have old software and the one in the baseline is newer).
After that i click on update to baseline, the process start and after 30 min more or less if finish rebooting the host. Then i ran a software scan of the host and find out that the installed software is still the same.
On the logs i'm seeing an XML formated output and at the end the below lines.
////////////////////////////////////////////////////////////////////////////////
// Exit Code for Node 10.11.81.21: 1
// HP Smart Update Manager for Node 10.11.81.21 Finished Mon Aug 3 2015 08:06:41
////////////////////////////////////////////////////////////////////////////////
I'm guessing the exit code 1 means something did not go write but i'm not sure what.
Does anybody know where should i keep searching? Any documentation that i might have missed?
Thanks in advance!
Fede
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-03-2015 10:22 PM
08-03-2015 10:22 PM
Re: HP SIM and ESXi
Hello,
You could start HPSUM, that's what you use and run it from a Windows or Unix server and scan the ESX server remote. Perhaps this will give more info. If i where you i would focus on HPSUM and also ask your question on the Proliant forum because this is not a real SIM question, you start HPSUM remote from HP SIM.
Andrew