Ignite-UX
Showing results for 
Search instead for 
Do you mean 

Ignite-UX on 11iv3 Itanium host - make_tape_recovery

SOLVED
Go to Solution
Super Advisor

Ignite-UX on 11iv3 Itanium host - make_tape_recovery

I run make_tape_recovery process on all my hosts against the root volume group. On one of my hosts the process ran fully but at the end reported this..
THE FOLLOWING LINE(S) HAD TOO FEW/INCORECT ENTRIES:
LINE 5 tmp/ 40770 1299092416 96 0 NA 3 0x52b 0x40000004

Then it says archive created succcessully.
Can anyone shed some insight on the the message above. Is 0x40 the minor number?
1 ACCEPTED SOLUTION
Acclaimed Contributor Acclaimed Contributor

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

[ Edited ]
4 REPLIES
Acclaimed Contributor Acclaimed Contributor

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

>LINE 5 tmp/ 40770 1299092416 96 0 NA 3 0x52b 0x40000004

This typically occurs because the filename has spaces or other junk in it. The "5" above is the length of the filename and I'm not sure how that "/" got there.
Acclaimed Contributor Acclaimed Contributor

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

[ Edited ]
Super Advisor

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

Thanks for the helpful info I was able to locate ths issue (filename). !!!
Highlighted
Super Advisor

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

I was able to locate the problem (filename) and remove it..thanks!