very urgent

[prassath]

hi ,

message follows

Main Menu: Enter command or menu > boot lan.147.128.43.12 install
Interact with IPL (Y, N, or Cancel)?> n

Booting...


after this it agian goes to the menu command , it does not show any errors,
if boot normally it loads
my subnetmask address, ipaddress are all fine
my network is also fine
os: 11.31 HPux
mode : HP 9000 rp3410

[Devender Khatana]

Hi,

Try just

>bo lan install

>bo IP_Address install


HTH,
Devender

[Bharat Katkar]

HI,

Are you abel to see your Ignite server.

Main Menu: Enter command or menu > sea lan install

If this display you 147.128.43.12, then try

Main Menu: Enter command or menu > bo lan. install

Hope that helps.
Regards,

[Luk Vandenbussche]

Hi,

Is your server in the same VLAN as your ignite server?

[prassath]

thanks for the reply

when i apply bo lan install
it goes for ipl, if i press n

it load isl and then hangs up

my ignite is fine , iam able boot from the other system

[prassath]

1,iam able to see my ignite server,
2,no my server is not under Vlan

[Bharat Katkar]

Since it show you in
Main Menu: Enter command or menu > sea lan install
that means it is in your subnet and it's not an issues.

Can you paste the output so that we can see where exactly it is hanging.

Most probably this should be an Ignite server related issue.

Regards,

[Pat Obrien_1]

Had similar issues when not using the core io lan card. I was told network boot must happen on core io lan port or the lowest identified from lanscan. I get around this by booting from a hpux cd, setup proper network device and ip etc,and then ignite from my ignite server.

[Geoff Wild]

You need to use lan0 - else you will need a boot helper.

Do a linkloop test from the ignite server to this one:

linkloop -i 0 0x00306E0FB224

Course - use the mac address of the server you want to install to...

Also - do you have an unused ip in /etc/opt/ignite/instl_boottab on the ignite server?


boot lan.147.128.43.12 install
That is the correct syntax to boot.

Rgds...Geoff