HPE Community
Integrity Servers
1753675 Members
5212 Online
108799 Solutions
New Discussion

Re: RX6600 EFI Boot Configuration

 
mikegw
Occasional Contributor

‎10-31-2014 09:33 AM

‎10-31-2014 09:33 AM

RX6600 EFI Boot Configuration

I need to replace a system I/O board on a RX6600 to resolve a cooling issue. Is there any way to transfer the EFI Configuration (especially the Boot config) to the new board? I was hoping to use the Console port but there doesn't appear to be any documentations that allows this. I'm running a Win2003 Enterprise OS and the replacement board has the defaul HP-UX boot config setup. I've tried to do it using the EFI Boot Manager but I'm not having any luck. 

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎11-03-2014 12:12 AM

‎11-03-2014 12:12 AM

Re: RX6600 EFI Boot Configuration

For a windows setup ypu need to save the boot config, otherwise it will be hard to restore.

 

Use the nvrambkp utility available from the product page to save the config to disk or USB.

 

http://h20566.www2.hp.com/portal/site/hpsc/template.PAGE/public/kb/docDisplay?docId=c03155532&ac.admitted=1415002257687.876444892.199480143


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.