- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - HP-UX
- >
- SecurePath 3.0F SP2 and VxVM ... Again
Operating System - HP-UX
1753569
Members
5939
Online
108796
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-12-2007 06:10 AM
01-12-2007 06:10 AM
SecurePath 3.0F SP2 and VxVM ... Again
Can someone please tell me if SecurePath V3.0F SP2 is supported with VxVM mirrored boot disks (locally attached, not SAN)? I've read thru some older threads where there were problems with the post install script, which is the problem I'm getting, but the thread ends with no resolution. The install guide has some limitations around using VxVM with a SAN boot device, but I'm not booting from SAN. I have an rx1620 with two internal hard drives (VxVM mirrored)and 11iV2.
On a side note, the system came pre-ignited with an LVM boot disk. I could not run the vxcp_lvmroot utility to convert to VxVM until I removed the target disk from DMP control. Then the conversion went fine. Could the SecurePath install issue be related or is it just flat out not supprted with VxVM whether SAN or local boot?
Thanks,
-Ron
On a side note, the system came pre-ignited with an LVM boot disk. I could not run the vxcp_lvmroot utility to convert to VxVM until I removed the target disk from DMP control. Then the conversion went fine. Could the SecurePath install issue be related or is it just flat out not supprted with VxVM whether SAN or local boot?
Thanks,
-Ron
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP