HPE Community
Operating System - HP-UX
1753403 Members
7136 Online
108792 Solutions
New Discussion

Re: changing output of command uname -a in hpux10.20

 
SOLVED
Go to solution
Torsten.
Acclaimed Contributor

‎01-12-2009 08:33 PM

‎01-12-2009 08:33 PM

Re: changing output of command uname -a in hpux10.20

The STATION ADDRESS actually is the MAC address - base for the system unique id.
For this reason you normally transfer a special eeprom from the old system board to the new on a few old systems. Other systems work different - on the first boot they ask you to input the original mac address values.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.