- Community Home
- >
- Networking
- >
- Wireless
- >
- M and MSM Series
- >
- Re: meshing issues 2 slaves
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2014 03:08 AM
10-01-2014 03:08 AM
meshing issues 2 slaves
Hello all
We have a msm760 controller and on a certain section of our site we wantto setup mesh links.
After much knashing of teach we managed to get 1 master and 1 slave to successfully mesh and reamin stable.
The issue now is..
as soon as we add a 2nd slave, when it tries to connect it knocks the 1st slave off. When we disconnect the 2nd slave the 1st comes back.
Alternatively if we disconnect the 1st slave then the 2nd slave joins without issue.
So for some reason it will only have 1 slave on at a time.
Any suggestions or thoughts please reply don't be shy.
thanks in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2014 03:39 AM
10-01-2014 03:39 AM
Re: meshing issues 2 slaves
to get some thoughts/replies going
could it be that the AP's are too close together?
instead of dynamic setup would static be better to force the links to stay up?
when in close proximity does 1 of the devices have to be an alternative master?
could it be a routing issue on the controller or local switch?
any ideas?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2014 09:22 PM
10-08-2014 09:22 PM
Re: meshing issues 2 slaves
Are those autonomous APs or Controller ? and which firmware is running ? Antennas ? Power and Channel ? which Radio are you using ?