HPE Community
Netservers
1752812 Members
6154 Online
108789 Solutions
New Discussion

Adaptive Load Balancing on LPr

 
Melissa Helgeson_1
New Member

‎09-06-2002 05:07 AM

‎09-06-2002 05:07 AM

Adaptive Load Balancing on LPr

I have 2 NICs installed on a LPr with Windows NT /SP6a. I am using the hpset utility to configure ALB. When all settings are correct, I lose connectivity to the network. If I remove ALB and disable 1 NIC, back to normal. I have these NIC's connected to a Cisco 3548 Switch. Any suggestions to help me figure this out?
0 Kudos
1 REPLY 1
Oliver Staehr
Frequent Advisor

‎09-09-2002 04:11 AM

‎09-09-2002 04:11 AM

Re: Adaptive Load Balancing on LPr

Hi!
Hm, this works fine for me (not with LPr but with LP2000r connected to Cisco 3548). Did you configure something special on the 3548 ?
What happens if you connect only one adapter from the alb-team to the 3548 ?
What driver release do you use ?
Regards, Oliver
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.