Network Management / (OpenView-NNM) Support and News Forum
Showing results for 
Search instead for 
Do you mean 

Filter Polling Results NNMi 9.05

Occasional Advisor

Filter Polling Results NNMi 9.05

Hi everyone


I'm polling servers with NNMi 9.0, and some windows servers rerturn 20+ interfaces


There are 2 problems with the list of interfaces:

1. In some servers all interfaces are at "Not Polled" status


2. I want to filter the list, so that only IpV4 (or pther criteria) will be returned,because it causes problems with our CMDB integration


Thanks : )

Honored Contributor

Re: Filter Polling Results NNMi 9.05

1. No all interfaces are "connected" meaning that there is not information available that NNMI can build a logical connection between the server and another device in the inventory. You can force polling on these.



2. Easy, create a filter.

Have a nice day :)

Andy Kemp,  CISSP
Occasional Advisor

Re: Filter Polling Results NNMi 9.05



I know that not all interfaces are connected, but 22 interfaces is not what I want to see as a SNMP result from a Microsoft server


Where can I crete a filter so that only the "Interfaces" tab at the nodes in the "Servers" group will be affected?

We must pay attention to the situation where the primary NIC fails, and the backup starts (teaming)



HPE Expert

Re: Filter Polling Results NNMi 9.05

Hello Community


Please visit our new customer forum if you have a valid SAID  support contract at the following link.


HP Support

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP

If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.