Network Management / (OpenView-NNM) Support and News Forum
Showing results for 
Search instead for 
Do you mean 

Management event configuration

Frequent Advisor

Management event configuration

Hi Team,

 

If i want to add and enable script for lifecycle state closed or registered for many events in management event configuration, how can i do it through a command, instead of adding it manually for each and every event.

 

Please suggest.

2 REPLIES
HPE Expert

Re: Management event configuration

[ Edited ]

Hello Abhishek

 

 

As Dave mentioned this is possible in 9.20 version.Otherwise you should submit an enhacement request in order to honor this feature.

 



HP Support

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP

If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.

HPE Expert

Re: Management event configuration

Hi Abhishek,

 

 You don't mention which version of NNMi you are using.  However with 9.20 a feature was introduced where you have two new commands

 

nnmincidentcfgdump.ovpl

nnmincidentcfgload.ovpl

 

  these will allow you to dump out one or more trap or incident configurations, edit the resulting xml and then reload it.  This effectively allows you to do bulk changes to the trap and incident configurations without the need to use the GUI.

 

  Please review the online help for more information on the options the tools take.

 

  All the best

 

Dave Y

HP Support
Viewed the Support tips? Search for "(NNMi) Support Tips" and order by Date to get the list
The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP
If you find this or any post resolves your issue, please be sure to mark it as an accepted solution.