Network Management / (OpenView-NNM) Practitioners Forum
Showing results for 
Search instead for 
Do you mean 

NNMi and Trap

SOLVED
Go to Solution
Frequent Advisor

NNMi and Trap

Hello every NNMi User

 

I would to know if there is a method to load trap in NNMi,

As after NNMi replace a numeric value in a trap by the value configured in the mib file

 

Here the custom attribute attach to the trap

.1.3.6.1.4.1.7779.3.1.1.1.2.2.0 asn_integ 4


and here the definition  of the varbind in the mib

ibTrapSeverity OBJECT-TYPE
	SYNTAX          INTEGER {
                         critical (5),   -- service impact problem
                         major    (4),   -- problem requiring user intervension
                         minor    (3),   -- problem not requiring user interv.
                         info     (2),   -- informational only
                         indetermined (1)
                        }
	MAX-ACCESS      accessible-for-notify
	STATUS          current
	DESCRIPTION     "It contains the serverity of the trap."
	::= { ibNotificationVarBind 2}


So I would like that NNMi directly tell that " ibTrapSeverity is major" and not .1.3.6.1.4.1.7779.3.1.1.1.2.2.0 asn_integ 4

thank you for your help

2 REPLIES
Highlighted
Honored Contributor

Re: NNMi and Trap

Hello Le_savoyard

 

If the mib has been correctly loaded then you can use the $text($<CIA_oid>) construct to replace the CIA_oid value with the corresponding text.

 

Your Incident message would look like:

 

ibTrapSeverity is $text($.1.3.6.1.4.1.7779.3.1.1.1.2.2.0)

 

See also the online help, search for "Functions to Generate Values Within the Incident Message"

And: http://support.openview.hp.com/selfsolve/document/KM964053

 

Kind regards

Dieter

 

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Frequent Advisor

Re: NNMi and Trap

Thank for the response