Network Management / (OpenView-NNM) Practitioners Forum
Showing results for 
Search instead for 
Do you mean 

NNMi and Trap

SOLVED
Go to Solution
Frequent Advisor

NNMi and Trap

Hello every NNMi User

 

I would to know if there is a method to load trap in NNMi,

As after NNMi replace a numeric value in a trap by the value configured in the mib file

 

Here the custom attribute attach to the trap

.1.3.6.1.4.1.7779.3.1.1.1.2.2.0 asn_integ 4


and here the definition  of the varbind in the mib

ibTrapSeverity OBJECT-TYPE
	SYNTAX          INTEGER {
                         critical (5),   -- service impact problem
                         major    (4),   -- problem requiring user intervension
                         minor    (3),   -- problem not requiring user interv.
                         info     (2),   -- informational only
                         indetermined (1)
                        }
	MAX-ACCESS      accessible-for-notify
	STATUS          current
	DESCRIPTION     "It contains the serverity of the trap."
	::= { ibNotificationVarBind 2}


So I would like that NNMi directly tell that " ibTrapSeverity is major" and not .1.3.6.1.4.1.7779.3.1.1.1.2.2.0 asn_integ 4

thank you for your help

2 REPLIES
Honored Contributor

Re: NNMi and Trap

Hello Le_savoyard

 

If the mib has been correctly loaded then you can use the $text($<CIA_oid>) construct to replace the CIA_oid value with the corresponding text.

 

Your Incident message would look like:

 

ibTrapSeverity is $text($.1.3.6.1.4.1.7779.3.1.1.1.2.2.0)

 

See also the online help, search for "Functions to Generate Values Within the Incident Message"

And: http://support.openview.hp.com/selfsolve/document/KM964053

 

Kind regards

Dieter

 

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Highlighted
Frequent Advisor

Re: NNMi and Trap

Thank for the response