Network Management / (OpenView-NNM) Support and News Forum
Showing results for 
Search instead for 
Do you mean 

Stopping the event correlation in monitoring the devices

Highlighted
Frequent Advisor

Stopping the event correlation in monitoring the devices

I have few set of servers which i want to monitor for node up or down. As per i know whenever a device goes down NNMi will find the Root cause and will never alert if the actual device is not down.  I do not want this to happen in case of a set of devices, i.e NNMi should also alert if the End device is not down but the intermediate devices are down, I.e No event correlation should take place. Any Help will be appreciated.

2 REPLIES
HPE Expert

Re: Stopping the event correlation in monitoring the devices

Hello  OMW

 

You  can double check the causal engine document to verify how the correlations work.

 

 

Please visit our new customer forum if you have a valid SAID  support contract at the following link.

 

http://h30499.www3.hp.com/t5/Network-Node-Manager-Support/bd-p/network-node-mgr-support-cust-forum#....

 

HP Support

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP

If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.

Valued Contributor Valued Contributor

Re: Stopping the event correlation in monitoring the devices

Hello there,

 

you can add the "special" servers or devices to the "Important Nodes" nodegroup.

 

Then a "node down" event is forced to be created, even if the status normally would become "unknown" due to correlation.

 

 Best regards,

 

    Iris