Optical Jukeboxes and Drives
1748195 Members
2650 Online
108759 Solutions
New Discussion юеВ

HP7200i

 
Stace Prieston
New Member

HP7200i

I am experiencing the following problem with my HP 7200i:

D0100: I/O error (05/2C/00) - Command error - commands not issued in sequence

I have the following software versions:
Adaptec DirectCD 4
Adaptec Easy CD Creator 4
HP Firmware Update v3.01

I had the same problems when I was using the 2.0 versions of the above.

When trying to record to a CD-R or CD-RW through Easy CD Creator. It goes through the testing phase OK
(shows "Test Successful" at the end). Then it goes into the recording phase. Shows "Preparing to write the track", then "Writing Table of Contents", then it ejects the CD and shows "Errors reported by output device".

I ran the diagnostics program with everything checking out. I am a lost of what to do next. I surfed the roxio.com website and found nothing that could help. I might have overlooked something I guess. Please advise.

Thanks,
Stace

 

 

P.S. This thread has been moevd from Storage > General to Optical Jukeboxes & Drives./ - Hp Forum moderator

 

 

 

 

GO Trojans GO
2 REPLIES 2
Roger Faucher
Honored Contributor

Re: HP7200i

Stace:

What OS are you running? If WIN2K, you need EZCD Creator 4.02 or later, if WINMe, version 4.02d or later. Let me know!
Make a great day!

Roger
Stace Prieston
New Member

Re: HP7200i

I am using WIN98SE, however I found the problem my self. I spent 15 hours T/S and found that the laser was dirty and I reinstalled all my software and updated drivers.

Thanks for the reply Roger.

Stace
GO Trojans GO