HPE Community
PCM
1753767 Members
5507 Online
108799 Solutions
New Discussion

HP 1920 Switch Discovery problem

 
spirou
Occasional Contributor

‎12-19-2014 02:12 AM - last edited on ‎12-21-2014 07:06 PM by

‎12-19-2014 02:12 AM - last edited on ‎12-21-2014 07:06 PM by

HP 1920 Switch Discovery problem

Hi!

I´m trying to do a manual discovery of my new switch 1920-24G with Procurve manager V 3.0.

No problem to discover my old 2626 and 2910.

Ip and netmask is set in switch and I get so far in the manual discovery as :

 

Checking read access community name...
Success...communication established with read community name

Checking write access community name...
Success...communication established with write community name

Communication was successfully established
with device 192.168.xxx.xxx

but the next step it stops

see attached file

 

 

P.S. This thread has been moved from ProCurve / ProVision-Based  to PCM. - Hp forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.