Performance Center Support and News Forum
Showing results for 
Search instead for 
Do you mean 

Sitescope monitor state after a Performance Center 11 test run

Valued Contributor

Sitescope monitor state after a Performance Center 11 test run

Using ALM Performance Center 11 with SiteScope 11.01 topologies to do the performance metric collection.

All the monitors are disabled once you have setup a topology. When you start a test run the monitors are enabled. I would therefore think they should be disabled after the end of the test run, but they stay enabled.

 

Does anyone know if this is the expected behaviour? It means SiteScope quickly becomes overloaded because multiple topology metrics are continuously running all the time after they are first run. Shouldn't really expect Perf Center users to have to go into SiteScope and manually disable them after each run.

 

3 REPLIES
HPE Expert

Re: Sitescope monitor state after a Performance Center 11 test run

Please check whether 'enable montors' option in Topology configuration is set to 'always'.

Highlighted
Valued Contributor

Re: Sitescope monitor state after a Performance Center 11 test run

No it is set to Automatically

HPE Expert

Re: Sitescope monitor state after a Performance Center 11 test run

It may be a defect, contact hp with relevant logs.