- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- HP 2920 link LACP load sharing
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-25-2015 11:51 PM
08-25-2015 11:51 PM
Hello
Have H3C S5500 switch using as aggregation switch,
interface bridge-aggregation1
port link-type trunk
port trunk permit VLAN all
link-aggregation mode dymanic
link-aggregation load-sharing mode source-ip
had to convert that set of commands on HP 2920 switch
which is done as
trunk <ports> trk1 LACP
having a little consfusion in what does the last line on H3C switch mean ?
how to make it on HP 2920 ?
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-26-2015 08:02 AM
08-26-2015 08:02 AM
SolutionThe "link-aggregation load-sharing mode source-ip" command on the 5500 is used to set the algorithm that the switch uses to determine which member of a link aggregation a flow should use. On the 2920, the default is to use source and desitination IP for IP packets and source and dest MAC addresses for non-IP packets. You can use the "trunk-load-balance" global command to choose either an L3 or L4 based algorithm. In you case, you can go with the default.