HP ProCurve 5400 web console issue

[Handshaw]

At K.14.65, ROM K.12.21 we could webview into our 10 zl switches

We upgraded to K.14.84, ROM K.12.22, and still could webview

We also had one switch upgraded to K.15.03.005 (don't like the interface, will avoid)

After the upgrade on 9/7/11 we started having some serious application communications delays/problems with out "Showcase" application.

After much application/server troubleshooting/frustration we finally decided to reverse the network upgrade.

So I downgraded ALL 10 zl switches back to K.14.65 and the problem went away?!?

So we are stuck at K.14.65, and like everyone else can no longer webview.

[Helper]

Hi,

For your information, i'm a partner we have had to wait until K.15.06.0009 or K.15.07.xxxx to upgrade our customers and obtain a stable situation regarding performwance, stability (dynamic routing, multicats, nlb, etc.).

Bye.

[Sumarwoto_Hadi]

Same as your problem, my 5406zl I also stagnated in the webgui login ..

My 5406zl initial firmware is k.14.34 I've tried to upgrade to K.15.02.0005 I even try to upgrade to K_15_06_0008 but has not been solved

If anyone has successfully

[parrottcf]

We had the same problem as well with the 15.06.0008 version we just put on for a new installation. The web interface was working prior with 15.02.0005, but not after. We would just get a login screen and entering the user name/pw wouldn't work. Found out from poking around the CLI that apparently the user name is reset to blank after the update. I got around the issue by leaving the user name blank and entering the management password and got into the web interface fine. From there, you can set a user name/pwd again for management and operator levels.