Aruba & ProVision-based
1748195 Members
3967 Online
108759 Solutions
New Discussion

How can I modify procurve configuration through SNMP

 
Vesen
Occasional Advisor

How can I modify procurve configuration through SNMP

Hello,

 

 

I would like to know if it's possible to remove a command from a ProCurve Switch using SNMP.

 

Like an idiot I have added this command : ip authorized-managers access method snmp.

And I can't connect to my switch with telnet or ssh. And obviously this switch is located 400km from my location.

 

I have configured the SNMP on the switch and it's working well on Cacti, but I can just get information.

 

 

So I have two options : traveling or configure it through SNMP.

 

 

Can you help me please ? 

Thank you.

 

 

P.S. This thread has been moved from  Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

6 REPLIES 6
Vince-Whirlwind
Honored Contributor

Re: How can I modify procurve configuration through SNMP

Vesen
Occasional Advisor

Re: How can I modify procurve configuration through SNMP

I have to download the Engineer’s Toolset for use these ?

Vesen
Occasional Advisor

Re: How can I modify procurve configuration through SNMP

I have tested the tool, but the problem is that it's only working with Cisco switch/router. It's not working with ProCurve Switch :(

 

Is there an other solution to download/upload configuration through SNMP pls ? I can't find something that I can understand on Google.

Vince-Whirlwind
Honored Contributor

Re: How can I modify procurve configuration through SNMP

Cisco only?
Sorry, I didn't know that...Are you sure? I think maybe the "Config Viewer" might be looking for Cisco-formatted files, but I don't see why the other two would care...?

Vesen
Occasional Advisor

Re: How can I modify procurve configuration through SNMP

When I'm trying to download or upload a configuration, I get an error : 192.168.0.254 is not a Cisco device. 

 

It's too bad, this soft was perfect.

Vesen
Occasional Advisor

Re: How can I modify procurve configuration through SNMP

Is it possible to configure a switch with snmp ?