Aruba & ProVision-based
1748134 Members
3518 Online
108758 Solutions
New Discussion юеВ

Re: Pulling the config off a 2810

 
MBNH
Occasional Collector

Pulling the config off a 2810

We just took over a facility where the I.T. left quite a while ago.  He left a log off all the equipment passwords, but we just noticed he never documented the credentials to access the e2810 switch.  No one can find him, so now we are stuck.  We can't just do a reset, because we don't have the current config table.  Is there any way to pull the configuration off of a Procurve e2810 without the admin credentials?

3 REPLIES 3
Patrick R
Frequent Advisor

Re: Pulling the config off a 2810

If he did not block the front panel button in the config, just press the clear buttopn on the switch and it will erase the configured manager and oparator passwords.

MBNH
Occasional Collector

Re: Pulling the config off a 2810

Thank you, Patrick!

 

To your knowledge, this will ONLY reset the passwords?  Not the config?

Patrick R
Frequent Advisor

Re: Pulling the config off a 2810

Yes, Only the password. the config remains unchanged.