- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: HP Ethernet 1Gb 4-port 366M Adapter shows only...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-18-2012 07:36 AM
12-18-2012 07:36 AM
HP Ethernet 1Gb 4-port 366M Adapter shows only two ports
Hi,
HP BL460c Gen8 into a C3000 enclosure. I use this server as a VMware ESXi 5.0 host. In vCenter ans HP Insight Control it shows the HP Ethernet 1Gb 4-port 366M Adapter with 4 ports and 2 of them are up, the other 2 are down.
When I look in the onboard admin of the C3000, it shows only 2 ports in the mezzanine card information, so I can't figure out where can I connect the two other ports. It looks like the ethernet adapter have only 2 ports.
Is this a limitation of the C3000 enclosure? If not, where can I configure the 2 other ports in order to make them available and connect them?
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-18-2012 11:38 PM
12-18-2012 11:38 PM
Re: HP Ethernet 1Gb 4-port 366M Adapter shows only two ports
hi,
Are you using mezzanine slot 1 ?
Please check here:
" If the 366M is installed in mezzanine slot 1 of a half-height server, connectivity will be provided on only 2 of the 4 ports."
Thanks
regards,